Maintenance; Drawer Handling; Replacing The Paper Roll - Sharp XE-A102 Manuel D'instructions

Maintenance

Drawer Handling

Locking the Drawer
Develop the habit of locking the drawer when not using the register for
any extended period of time.
To lock the drawer, turn 90 degrees counter-clockwise, and to unlock
the drawer, turn 90 degrees clockwise.
Removing the Drawer
To detach the drawer, pull it forward fully, and remove it by lifting it up.
The 6-denomination coin case is detachable from the till. Also the
separators of the coin case are removable.
Manually Opening the Drawer
In case of a power failure or if the machine is out of order, slide the
lever located on the machine bottom toward the direction of the arrow
to open the drawer manually. The drawer will not open if it is locked
with a drawer lock key, though.
Using the Slit of the Drawer
You can enter bills and cheques from the slit without opening the drawer. The bills and cheques
entered are placed under the coin case.
When taking out the bills and cheques, never fail to hold tightly the both sides of the
Caution
coin case with your both hands so that the coins in the coin case will not be fallen.

Replacing the Paper Roll

When a dye appears on the paper roll, it is time to replace the paper
roll with new one. Be sure to use the paper roll specified in
"Specification" section.
In case of journal printing
1. Set the mode switch to the REG position.
2. Remove the printer cover.
3. Press o to advance the paper by several lines and then cut it to
remove the take-up spool from the bearing.
4. After cutting the existing paper, remove the paper roll. Then remove
the remaining paper by pressing o.
5. Remove the paper roll from the take-up spool.
6. Install a new paper roll and replace the take-up spool according to
the instructions on page 6.
In case of receipt printing, do the above steps 1, 2, 4 in this
order and then install a new paper roll according to the
instructions on page 6.
24