Publicité
Les langues disponibles
Les langues disponibles
Functions
• This Trix model complies with the regulations con-
cerning suppression of interference with radio and
television reception.
• An electronic overload protection is built in protect
the model.
• Built-in electronic circuit for oberation with an
conventional DC power pack, Trix Selectrix or NMRA
DCC digital.
• The mode of operation is automaticaly recognized.
• Analog 14 volts DC, digital 22 volts AC.
Safety Information
• Not suitable for locomotive controllers with pulse
width control.
• Not suitable for continuous train lighting on analog
layouts.
• Not suitable for Trix ems.
• The locomotive must not be connected to more than
one power source at a time.
• This Locomotive ist to be used only with an operat-
ing system designed for it.
• Pay close attention to the safety warnings in the
instructions for your operating system.
6
Notes on digital operation:
• The operating instructions for your central unit
(examplare: Mobile Station) will give you exact proce-
dures for setting the different parameters.
• The values set at the factory have been selected to
insure trouble-free operation.
• This locomotive comes from the factory programmed
for the digital address „03" (Selectrix) / „03" (DCC).
• This locomotive with the settings made at the factory can-
not be operated with opposed polarity DC power in brak-
ing track blocks. If this feature is desired, then you must do
without conventional DC operation (CV 29 / bit 2=0).
• Malfunctions resulting from changes to the factory
settings of the locomotive electronics are caused by
the operator and do not give grounds for complaint
under our guarantee or warranty obligaions.
• The programming for the Selectrix function is done
in the same mariner as discribed in the instructions
for the 66838 decoder.
No warranty or damage claims shall be accepted in those cases
where parts neither manufactured nor approved by Trix have
been installed in Trix products or where Trix products have been
converted in such a way thad the non-Trix parts or the conver-
sion were causal to the defects and/or damage arising. The
burden of presenting evidence and the burden of proof thereof,
that the installation of non- Trix parts or the conversion in or of
Trix products was not causal to the defects and/or damage aris-
ing, is bome by the person and/or company responsible for the
installation and/or conversion, or by the customer.
Publicité
