Final Tubing Check; Wireless Remote Control Installation - Carrier DLFEHA Serie Instructions D'installation

DLFEHA: Installation Instructions

FINAL TUBING CHECK

IMPORTANT: Ensure certain factory tubing on the indoor unit has not
shifted during shipment. Ensure tubes are not rubbing against each other
or any sheet metal. Pay close attention to feeder tubes, making sure wire
ties on feeder tubes are secure and tight.
Drain Connections
Connect the drain line. The drain line must not have a trap anywhere in its
length, must pitch downwards, and must be insulated up to the outside
wall (see Fig. 27). By default, the drain hose is attached to the left−hand
side of unit (when facing the back of the unit). However, it can also be
attached to the right−hand side.
a. To ensure proper drainage, attach the drain hose on the same
side that your refrigerant piping exits the unit.
b. Attach a drain hose extension (purchased separately) to the end
of drain hose.
c. Wrap the connection point firmly with Teflon tape to ensure
good seal and to prevent leaks.
d. For the portion of the drain hose that will remain indoors,
e. Wrap it with foam pipe insulation to prevent condensation.
f. Remove the air filter and pour a small amount of water into the
drain pan to ensure that water flows from the unit smoothly.
Plug the Unused Drain Hole
To prevent unwanted leaks you must plug the unused drain hole with the
rubber plug provided.
P r o p e r Do not form a rise
Fig. 27 — Proper Drain Hose Installation
NOTE: For proper orientation of the refrigerant piping, electrical
cable and drain lines, refer to Fig. 28.
Indoor Unit
Drain hose
Signal wire
Fig. 28 — Bundle drain hose, refrigerant pipes, & signal cable
NOTE: For applications where gravity cannot be used for drainage, a
condensate pump accessory is available. Consult the condensate
pump Installation Instructions for more information.
Manufacturer reserves the right to change, at any time, specifications and designs without notice and without obligations.
D o n t o p t u d r a n i e n d n i o t w a e t r
Space behind unit
Refrigerant piping
Insulation tape
WIRELESS REMOTE CONTROL
INSTALLATION
Mounting Bracket (if installed on the wall)
1. Use the two screws supplied with control to attach the mounting
bracket to the wall in a location selected by customer and within
operating range.
2. Install batteries in the remote control.
3. Place the remote control into the remote control mounting bracket.
NOTE: For remote control operation, refer to the unit owner's
manual.
WIRED REMOTE CONTROLLER
INSTALLATION
For setup instructions, refer to the wired controller installation manual.
1. Use the multi−function board supplied.
Fig. 29 — Multi Function Board
2. Use needle nose pliers to cut a hole on the multi-function board for
wiring.
Fig. 30 — Cut a hole on the multi-function board
3. Cut the female plug from the cable supplied with the wired remote
controller and strip the wires to connect to the adaptor board.
Fig. 31 — Cut the female plug and strip the wires
14