Mounting Position; Conditions On Site; Mechanical Installation - HBM TB1A Notice De Montage

12

4.2 Mounting position

The reference torque measuring disc can be installed in any position. With
clockwise momentum, there is a positive output signal in conjunction with the
HBM measuring amplifiers.

4.3 Conditions on site

The TB1A reference torque measuring discs are protected to IP54 according
to EN 60529. The measuring discs must be protected from dirt, dust, oil,
solvents and humidity.
During operation, the prevailing safety regulations for the security of
personnel must be observed.

4.4 Mechanical installation

NOTE
Handle the reference torque measuring disc carefully. The transducer
might suffer permanent damage from mechanical shock (dropping),
chemical effects (e.g. acids, solvents) or thermal effects (hot air, steam).
CAUTION
You must not loosen the screwed joints of the measuring body and
mounting flange and the slotted screws of the identification plate
marked at the factory by safety paint.
HBM
TB1A
A0162 7.0 en/de/fr