Lifting And Placing On Other Means Of Transport - Zipper Maschinen ZI-RPE120GYN Mode D'emploi

18.2 Lifting and placing on other means of transport

Two people are required to lift and place the machine on another means of transport - one
person to operate the hoist and one person to keep the machine in balance.
1. When transporting over long distances, fold the handle forward as far as possible.
2. Make sure that the lifting device including accessories is designed for the weight of the
machine.
3. Check the fixing of the lifting frame before lifting
4. Lift the machine only a few centimetres to check the load capacity.
5. Than lift the machine as gently as possible afterwards to the desired position.
6. Secure the load properly for transport.
19 STORAGE
1. If the machine is not used for a longer period of time (>30 days):
2. Empty the oil tanks and fuel tanks.
3. Remove the spark plug and pour a few drops of engine oil into the cylinder. Using a
rope starter, turn the engine a few times so that the oil is well distributed inside the
cylinder. Clean the spark plug and replace it.
4. Cover the cooled machine and store it out of the reach of children and unauthorised
persons in a well-ventilated, dry and frost-free environment.
20 DISPOSAL
Do not dispose of your machine in residual waste. Contact your local authorities for
information on available disposal options. If you buy a new vibratory plate or equivalent
from your dealer, he is obliged in certain countries to dispose of your old machine
properly.
21 TROUBLESHOOTING
Hot surfaces and rotating machine parts while the engine is running can cause
serious injury or even death. Always stop the machine before carrying out
troubleshooting work and secure it against unintentional restarting.
Fault
Motor does not start
Motor stops
Engine does not deliver
enough power:
Insufficient vibration
Machine does not move
freely
ZIPPER MASCHINEN GmbH
ZI-RPE120GYN
www.Zipper-Maschinen.at
N O T I C E
W A R N I N G
Possible cause / remedy
Check O /O switch and make sure it is positioned to "O

N FF
Check fuel supply.

Check engine oil level (a sensor prevents starting if oil level

is too low).
Make sure that the spark plug ignition cable is connected.

Check spark plug

Check carburettor and air filter and make sure they are

clean.
Check fuel supply.

Check that the fuel tap is open.

Check oil levels.

Check the condition of the air filter.

Check fuel supply.

Check that the fuel tap is open.

Check the condition of the air filter.

Check throttle position

Check whether the V-belt slips or is lost.

Check throttle position

Check the underside of the disc for buildup.

".
N
35