Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
16.4
Stopping the Machine
16.4.1 Emergency Stop
In case of danger and/or in an emergency situation, you can quickly switch off the vibratory
plate with the speed governor by pushing it completely into the S
16.4.2 Switching off the machine
1. Set the upper throttle lever to "minimum" and let the engine run idle for approx. 3
minutes at low engine speed.
2. Then set the engine O
3. Close the fuel switch.
4. Wait until the engine has cooled down before storing the machine.
17
MAINTENANCE
Hot surfaces and rotating machine parts while the engine is running can cause
serious injury or even death. Always switch off the machine for conversion,
adjustment, cleaning and maintenance work and secure it against unintentional start-
up.
17.1
Maintenance and servicing plan
17.1.1 Table of Activities
What to do?
Check fuel level
Check engine oil level
Control of the operating elements
Check for damaged parts
Checking for loose or lost screws
Change engine oil
Check V-belt
Change exciter oil
air filter cleaning
spark plug test
The specified intervals refer to working under "normal" operating conditions. Depending on the
load, a change/exchange may also be necessary at an earlier point in time.
ZIPPER MASCHINEN GmbH
ZI-RPE120GYN
/O
N
FF
www.Zipper-Maschinen.at
switch (ignition switch) to the O
W A R N I N G
When to do / how often?
before each start-up
before each start-up
before each start-up
before each start-up
before each start-up
first after 20 h, then every 100 h
every 50 h; replacement after 300 h or 1
year
every 200 h
every 50 h, replacement after 300 h or 1
year
every 100 h; replacement after 300 h or 1
year
position.
TOP
position.
FF
31
Publicité
Table des Matières
