Publicité
Les langues disponibles
Les langues disponibles
are completely dry before repositioning them. To remove and replace these filters, see
the instructions in point H1. This operation should be performed at regular intervals.
2. CARBON FILTERS
Hood not set up for carbon filter.
3. CLEANING THE OUTSIDE OF THE APPLIANCE
It is advised to clean the external hood surfaces at least every 15 days in order to avoid that
oily or greasy substances affect the steel surfaces.
The ouside of the range hhod should be cleaned using a damp cloth and neutral liquid
detergent or denatured alcohol.
In case of fingerprint-less finish (fasteel) clean only with water and neutral soap using clean
with a soft cloth, rinse and wipe dry thoroughly. Do not use products that contain abrasive
substances, rough cloths or cloths specifically designed for cleaning steel. Using abrasive
substances or rough cloths will inevitably damage the finish of steel. The steel surface will
be irrevocably damaged if the instructions above are not complied with.
Keep these instructions together with the instructions for use of your hood.
The manufacturer accepts no liability for any damage caused by non-compliance with the
instructions above.
4. CLEANING THE INSIDE OF THE APPLIANCE
The electrical parts or parts of the motor assembly inside the range hood must not be
cleaned using liquids or solvents.
Do not use abrasive products. All the above operations must be performed after hav-
ing disconnected the appliance from the mains power supply.
M
WARRANTY
The new equipment is covered by warranty.
The warranty conditions are provided by the distributor.
The manufacturer is not liable for any inaccuracies in this booklet resulting from
printing or transcription errors. The manufacturer reserves the right to modify its
products as it considers necessary or in the interests of the user, without compromis-
ing their essential safety and operating characteristics.
N
HOOD ASSEMBLY
WARNING: Failure to install the screws or fixing device in accordance with these instructions
may result in an electric shock hazard.
- Make a hole on the false ceiling according to the drawing indications at the beginning of
this booklet. Fasten the additional reinforcement template, supplied, to the internal part of
the false ceiling that is not visible, as shown in figure 10
ATTENTION the false ceiling must be suitably reinforced to support the range hood safely.
Note: in the event that the plastic check valve is used, it is recommended to mount it on the
conveyor outlet if the UM is mounted on the hood; otherwise, install it on the fitting in the
FC flange. To fit the valve, follow the instructions on its packaging.
- Remove the side glass panels. The panels are associated with the LED strips that provide
lighting, therefore the connector must be disconnected.
26
Publicité
