Publicité
Les langues disponibles
Les langues disponibles
' ' key: Pressing the key will decrease motor speed. If the 1st speed is active, pressing the key
switches the motor off.
' ' key: If the motor is turned off, pressing the key activates the motor at the 1st speed. If the
motor is running, pressing the key increases the motor speed to the maximum speed.
Timer key: If the motor is active, pressing the timer key activates/deactivates the timer function
Changing the radio control transmission code (only in the event that there are seve-
ral hoods close to each other and they need to operate independently)
Press the Light key together with the radio control Timer key until the blue LED starts
flashing slowly. If the "-" key on the radio control is pressed within 5 seconds, the new code will
be generated and saved. Saving is confirmed by 3 short flashes of the LED.
Every time a new code is generated or the radio control default code is set,
you must carry out the "Associating the radio control with the hood" procedure (pushbutton
panel Light key) described above.
To return to the default code, press the "-" and "+" keys together for over 5 seconds. Successfully
saving the default code will be signalled by 3 short flashes of the LED.
H
METALLIC FILTERS AND CARBON FILTER
1 METAL FILTERS
In order to access the metal filters, the mobile part must be lowered in assistance mode (de-
scribed above) by following this procedure: when all the LEDs on the keyboard are switched
off (light and motor off ) pressing and holding the key allows the mobile part of the hood to be
lowered for maintenance. In this state, the motor cannot be activated. Keys T2..T5 are inhibited.
Remove the metal filters fastened with magnets to the mobile part, pulling them gently to-
wards the outside of the hood.
Clean the metal filters as described in section L1 and put them back in place carefully on the
mobile part of the hood.
To close the mobile part in assistance mode: press and hold key 1. Keys T2..T5 will start work-
ing again.
2. ACTIVATED CARBON FILTERS
Hood not suitable for a carbon filter and therefore the internal recirculation version cannot be
installed.
I
LIGHTING
The range hood is equipped with high efficiency, low consumption LED spotlights with ex-
tremely long duration under normal use conditions.
L
MAINTENANCE AND CLEANING
Constant maintenance ensures the correct operation and efficiency of the appliance over time.
Special attention should be paid to the metal grease-trapping filters and the charcoal filters.
Frequent cleaning of the filters and their supports will ensure that fats and grease do not ac-
cumulate on the range hood, with the consequent risk of fire.
1. METAL GREASE-TRAPPING FILTERS
These trap the fat and grease particles suspended in the air, and therefore should be
washed every month in hot water and detergent, without bending them. Wait until they
ASSEMBLY AND REPLACEMENT
25
Publicité
