Hestan Cue KRCR24 Mode D'emploi page 35

FINAL INSTALLATION
MOUNTING THE HANDLES AND ENDCAPS
Handles and endcaps are provided with all stainless and color models. Handles are located in
protective wrapping, taped to the back of the refrigerator. Remove the handles before moving
the refrigerator into its cut-out or opening. Endcaps are located in a cardboard box inside the
refrigerator.
It is recommended that two people work together to assemble and apply the handles and
endcaps. Follow the steps below to complete the mounting process.
(CONT.)
Insert the handle into the endcaps and position the
endcaps over the supports that are pre-mounted on
the door and drawer.
• Use caution not to scratch the door surface.
• It is recommended that one person holds
the handle and endcaps in position while the
second person inserts the provided set screws
used to secure the handle.
The provided set screws are located in the box
with the endcaps. Using a 2.5 mm hex wrench,
insert the set screw into the hole in the endcap
and carefully tighten. The endcap is then properly
secured to the door/drawer. Repeat this step for
the other endcaps.
2019 Hestan Commercial Corporation
EN
33