Hestan Cue KRCR24 Mode D'emploi page 33

FINAL INSTALLATION
ANTI-TIP SAFETY
To avoid danger of the appliance tipping over it is mandatory to secure
the appliance to the wall by means of the two provided brackets.
MOUNTING SAFETY ANTI-TIP BRACKETS - All except KRP
series
When using the anti-tip brackets, they should be applied as illustrated using the provided
screws and wall anchors.
1) Find the mounting holes on top of the appliance, and determine how the bracket must
align with the wall.
2) Mark the wall where the holes are needed.
3) Drill the wall with an 5/16" [8 mm] bit and insert
the wall anchor.
4) Position the bracket and secure it first to the
appliance, then to the wall.
In addition, it is suggested:
• The side trim pieces on both sides must be secured
to the unit with the provided screws
• The side trim pieces must be screwed to the
cabinets at all provided attachment points.
• The cabinet must be securely attached to the wall
to assure the stability of the appliance.
When two units are installed together, the anti-tip
brackets are required for each of them.
In addition, the correct joining kit must be installed and
the units must be secured to the adjoining cabinets by
means of the side trim pieces, as above.
(CONT.)
1
2
3
4
2019 Hestan Commercial Corporation
EN
31