Hestan Cue KRCR24 Mode D'emploi page 27

OVERLAY PANELS
MOUNTING OVERLAY PANELS TO DRAWER
1
2
3
(CONT.)
Once all brackets and small brackets have been
applied to the panels, you can begin installing
the bottom drawer panel.
Leave the vertical adjustment screws
1
just a few turns in.
Mount the bottom drawer panel: Make
2
sure the height adjustment screw heads are
under the adjusting brackets. Then fit the
attachment brackets over the hanger bolts.
Final adjustment must be done after the
appliance is in place and the side trim mounted.
Use the height adjustment screws to align panels
3
to adjacent cabinets.
The panel has some adjustment sideways when
the hanger bolts are slightly loose.
Depth alignment: working from the inside of
the drawer, use the depth adjusting screws
4
(4) to push the panel away from the door as
needed, and snug the hanger bolts (5) to
secure the panel in place.
5
2019 Hestan Commercial Corporation
EN
25