Hestan Cue KRCR24 Mode D'emploi page 26

OVERLAY PANELS
PREPARING DOOR AND DRAWER FOR OVERLAY PANELS
The adjusting screws and hanger bolts must be threaded into place in the door (and drawer, if
EN
applicable) before applying the decorative panels.
Install the vertical adjustment screws into the bottom of the drawer (if applicable) 2-3 turns
deep. The vertical adjustment screws for the door panel are installed after applying the door
panel.
Install one hanger bolt into each recess - only 2-3 turns deep.
Install one depth adjustment screw into the holes above or below each recess - the wrench
opening goes in first so adjustments can be made from the appliance side of the door. These
should be screwed in almost flush to the face of the gasket surrounding them.
The depth adjustment screws can be started and screwed in much of the way by hand. If
needed, they can be finished using a 4mm allen wrench from the inside of the door or drawer -
gently pull the door gasket aside to reveal the screw hole.
1
Depth adjustment screw:
Install with socket toward
appliance
24
©2019 Hestan Commercial Corporation
(CONT.)
Location of vertical
adjustment screws in
drawer
Vertical adjustment screw
Hanger bolt
4
5
NOTE: Vertical adjustment
screws for door are installed
after hanging panel on door
(4) Depth adjust screws - these
adjust spacing between door
and panel
(5) Hanger bolts - these
secure the panel