Hestan Cue KRCR24 Mode D'emploi page 34

FINAL INSTALLATION
MOUNTING SAFETY ANTI-TIP BRACKETS - KRP series
To avoid danger of the appliance tipping over it is
EN
mandatory to secure the appliance to the wall by
means of the two provided brackets.
1) The appliance has one screw in place where each
bracket will attach. (See figure to right.) Remove
the screws and set aside.
2) Determine location of brackets and mark the
wall accordingly. Note that the brackets can be
installed facing in or out, as preferred.
3) Roll the unit away from the wall, and mark the hole
locations.
4) Drill anchor holes and install the anchors.
5) Mount the bracket to the wall, then roll the
appliance into position and attach the bracket
to the appliance using the screws saved from (1)
above.
In addition, it is suggested:
• The side trim pieces on both sides must be
secured to the unit with the provided screws
• The side trim pieces must be screwed to the
cabinets at all provided attachment points.
• The cabinet must be securely attached to the wall
to assure the stability of the appliance.
When two units are installed together, the anti-tip
brackets are required for each of them.
In addition, the correct joining kit must be installed
and the units must be secured to the adjoining
cabinets by means of the side trim pieces, as above..
32
©2019 Hestan Commercial Corporation
(CONT.)
1
Anti-tip
mounting
screws
3
4
5
2