Hestan Cue KRCR24 Mode D'emploi page 12

LOCATION AND PREPARATION
PREPARING THE INSTALLATION
Transport to installation site and unpacking
EN
Since this is a large and heavy appliance, before transporting the appliance, check the access to
the location where it will be installed (door size, maneuvering space in stairwells, etc.).
The side trim, door handles (non OV models), grill, and possibly other items will be packaged
on the back of the appliance. Be sure to remove those items and related packaging before
attempting to remove appliance from pallet.
The appliance is attached to the base of the packaging (pallet) through four bolts which can
be removed using a 17 mm (11/16") wrench.
It is recommended to use a pallet jack or other transporting device to move the appliance to
the installation site, and only at this point to remove the base of the packaging.
The appliance should always be transported in a vertical position. If this is not possible,
transport the appliance laying on its rear side.
Once at the installation site, the appliance, which is equipped with four wheels, can be taken
off the pallet and positioned in the installation area.
Removing appliance from pallet:
1) Take off the four bolts  securing the appliance to the pallet by means of a 17 mm
(11/16")wrench.
2) Remove the rear hold down brackets .
3) To remove the front fixing brackets , unscrew the rear wheel adjusting bolts  one or
two turns using a 13 mm wrench. This will release the front fixing brackets  so you can
remove them.
4) From the back of the unit and by means of a suitable, heavy-duty hand truck, remove the
appliance and place it on the floor.
Be very careful to avoid any damage to floors. Delicate floors should be protected with
plywood, hard cardboard or similar.
The appliance is very heavy.
Take great care during handling to avoid injury.
The appliance should always be transported in
a vertical position.
Avoid at all costs leaning it on its front side.
10
©2019 Hestan Commercial Corporation
(CONT.)
2
1 3
4
1