Hestan Cue KRCR24 Mode D'emploi page 16

CONNECTIONS
KRP MODELS
Connect as follows:
EN
Unwind the electric cord and connect it directly to the wall socket.
Observe the information display. If the
appliance is not in Stand-by condition or
if any lights are on, press the On/Off
button for three seconds to switch it off.
Connect the water line to the threaded
connection at the base of the unit. (1)
Fit the other end of the hose (2) to the water valve, use the gaskets provided in the Owner's
Kit.
Firmly tighten by hand - a tool/wrench should not be
needed to make a proper seal.
Turn on the water and ensure all connections are not
leaking prior to pushing the unit into the opening.
ALL OTHER MODELS
Connect as follows:
Unwind the electric cord and connect it directly to the
wall socket.
Observe the information display. If the appliance is not in Stand-by condition or if any lights
are on, press the On/Off
Push the 1/4" source waterline fully into the elbow connector then thread the elbow adapter
to the solenoid at the back of the appliance.
Firmly tighten by hand - a tool or wrench should not be needed to make a proper seal.
Turn on the water and ensure all connections are not leaking prior to pushing the unit into the
niche.
Electrical
connection
Water
connection
14
©2019 Hestan Commercial Corporation
(CONT.)
button to switch it off.
Back of appliance
Back of appliance
Electrical connection Water connection
Front of
appliance
1
2