Troubleshooting - Mac allister MPWP2700 Mode D'emploi

MPWP2700 by MacAllister

Troubleshooting

Suspected malfunctions are often due to causes that the users can fix themselves.
Therefore check the product using this section. In most cases the problem can
be solved quickly.
WARNING! Only perform the steps described within these
instructions! All further inspection, maintenance and repair work must
be performed by an authorised service centre or a similarly qualified
specialist if you cannot solve the problem yourself!
Problem
1. Product does
not start
2. Product does
not reach full
power
3. Oil leak
MNL_MAC_GB_High pressure cleaner_MPWP2700_V5_200528.indd 35
Possible cause
1.1. Not connected to
power supply
1.2. Power cord or plug is
defective
1.3. Other electrical
defect to the product
1.4. Trigger lock has not
been deactivated
1.5. Nozzle clogged
2.1. Extension cord not
suitable for operation
with this product
2.2. Power source (e.g.
generator) has too
low voltage
2.3. Air vents are blocked 2.3
2.4 Water inlet volume is
too low
2.5 High-pressure hose
is leaking
2.6 Seals worn
2.7 Intake filter dirt
2.8 Air being sucked into
the system
3.1. Seals worn
Troubleshooting
Solution
1.1. Connect to power supply
1.2. Contact your nearest
authorised service
centre
1.3. Contact your nearest
authorised service centre
1.4. Unlock the trigger
1.5. Clean the nozzle
2.1. Use a proper extension
cord
2.2. Connect to another
power source
Clean the air vents
2.4 Increase water inlet
quantity
2.5 Replace high-pressure
hose
2.6 Contact your nearest
authorised service
centre
2.7 Clean the filte
2.8 Check tightness of hose
fitting
3.1. Contact your nearest
authorised service
centre
EN EN
35
5/28/20 8:31 AM