Operation - Mac allister MPWP2700 Mode D'emploi

Operation

EN EN
Operation
WARNING! Do not operate the product with a closed water tap! This
leads to dry running and subsequently damages the product!
Kickback forces result from squeezing the trigger! Therefore, always
hold the spray gun with both hands!
Pay attention to safe posture! Improper handling can lead to injuries!
WARNING! Do not operate the product when the ambient temperature
is below 0 °C. Water will freeze inside the product and damage it.
1. Active both brakes to lock the rear wheels
of the product.
2. Connect the product to water supply as
described.
3. Turn on the water tap fully.
4. Hold the spray gun (9) with both hands.
5. Direct the nozzle away from yourself towards
the surface to be cleaned (Fig. 22).
6. Unlock the trigger (9d) and squeeze it until a constant amount of water flows
through the nozzle to allow air trapped in the hose to escape.
7. Release the trigger and switch the product on.
8. Hold the spray gun (9) with both hands. Direct the water jet to the object to be
cleaned and squeeze the trigger.
WARNING! Beware of kickback when squeezing the trigger!
Note: Always keep a reasonable distance between the nozzle and
the object to be cleaned in order to avoid damage. Ask your specialist
dealer for advice if required.
9. Release the trigger to stop the water jet.
28
MNL_MAC_GB_High pressure cleaner_MPWP2700_V5_200528.indd 28
MPWP2700 by MacAllister
Fig. 22
5/28/20 8:31 AM