Mac allister MPWP2700 Mode D'emploi page 30

Operation / Care and maintenance
EN EN
After use
1. Release the trigger (9d) (Fig. 23).
2. Turn the on/off switch to "0" position.
3. Turn off the water tap.
4. Squeeze the trigger to release the pressure still present in the product.
WARNING! Only separate the high-pressure hose from the spray
gun and the water hose from the product when no more pressure
exists in the system! Also ensure that the product is turned off and
separated from power supply!
5. Lock the trigger.
6. Separate the water hose from the water supply and then from the water inlet
hose adaptor (21).
7. Wind the pressure hose (3) onto the hose reel (2). Ensure that the hose is not
bent or twisted but winded up evenly.
8. Dismantle the accessories in the reverse sequence of the assembly
instructions if you are not going to use this product for a long period of time.
9. Check, clean and store the product as described below.
The golden rules for care
WARNING! Always squeeze the trigger to release the pressure still
present in the product first
Always switch the product off, disconnect it from the power supply and
let the product cool down before performing inspection, maintenance
and cleaning work!
1. Keep the product clean. Remove debris from it after each use and before
storage.
2. Regular and proper cleaning will help ensure safe use and prolong the life of
the product.
30
MNL_MAC_GB_High pressure cleaner_MPWP2700_V5_200528.indd 30
9d
0
Fig. 23
MPWP2700 by MacAllister
5/28/20 8:31 AM