INVENTOR M3GHP290-12 Manuel D'utilisateur page 13

|Installation |Installation
Note: Once the Exhaust Hose assembly and
Adjustable Window Slider are prepared, choose
from one of the following installation methods.
Type 1: Hung Window or Sliding Window
Installation (optional)
Foam seal B
(Adhesive type-shorter)
Foam seal A
(Adhesive type)
1. Cut the foam seal (adhesive type) to the
proper length and attach it to the window
frame.
Window slider B
Window slider A
(if required)
2. Attach the window slider kit to the window
opening.
Foam seal C
(Non-adhesive type)
3.Cut the non- adhesive foam seal C strip to match
the width of the window. Insert the seal between
the glass and the window frame to prevent air and
insects from getting into the room.
Security Bracket
2 Screws
4.If desired, install the security bracket with 2
screws as shown.
MODEL B
5.Insert the window slider adaptor into the hole
of the window slider.
EN
Foam seal B
(Adhesive type-shorter)
or
Foam seal A
(Adhesive type)
Window slider B
or
(if required)
Window slider A
Foam seal C
(Non-adhesive type)
or
Security
Bracket
or
2 Screws
or
MODEL A
or
Type 2: Wall Installation (optional)
1.Cut a 125mm (4.9inch) hole into the wall
for the Wall Exhaust Adaptor B. 2.Secure the
Wall Exhaust Adaptor B to the wall using the
four Anchors and Screws provided in the kit.
3.Connect the Exhaust Hose Assembly (with
Wall Exhaust Adaptor A) to the Wall Exhaust
Adaptor B.
Expansion anchor
position
Wall Exhaust
Adaptor B
Adaptor cap
Note: To ensure proper function, DO NOT
overextend or bend the hose. Make sure that
there is no obstacle around the air outlet of the
exhaust hose (in the range of 500mm) in order
to the exhaust system works properly. All the
illustrations in this manual are for explanation
purpose only.
Your air conditioner may be slightly different.
The actual shape shall prevail.
VENT CONTROL feature
The Vent Control is located at the back of the
air conditioner. The OPEN position removes
stale air from the room and exhausts it to the
outside. Fresh air is drawn in through normal
passages in the home.
When not need to circulate the room air, set
Vent Control to CLOSE position. This function is
only applicable for MODEL B.
Note: Cover the hole
using the adaptor cap
when not in use.
max 120cm or 47 inch
min 30cm or 12 inch
CLOSE
OPEN
13