Chamberlain LiftMaster PREMIUM Serie Mode D'emploi page 28

Door Control
Control Panel Setup
LOCK
NOTE: Your remote controls will NOT work when
LOCK mode is active however your keyless entry
will still allow access to your garage.
Activate: Press and hold the LOCK button for 2
seconds. The command LED will flash as long as
the lock feature is activated and your handheld
remote control will not operate your door at this
time.
Deactivate: Press and hold the LOCK button again
for 2 seconds. The command LED will stop flashing
and normal operation will resume.
LIGHT
To change the amount of time the garage door opener lights will stay on:
Press and hold the LOCK button until the garage door opener lights flash.* The time interval is indicated
by the number of flashes.
Number of times garage door opener lights flash
1
2
3
4
To cycle through the time intervals repeat the step above.
* Approximately 10 seconds
Command LED
LOCK Button
Time the garage door opener light stays on
1 1/2 Minutes
2 1/2 Minutes
3 1/2 Minutes
4 1/2 Minutes
LIGHT FEATURE (Default is Active)
Deactivate:
Press and hold the LIGHT button until the garage
door opener lights turn on, then off again.*
Activate:
Start with the garage door opener lights on. Press
and hold the LIGHT button until the garage door
opener lights turn off, then on again.*
NOTE: If the command LED is continuously
blinking, the LOCK feature needs to be deactivated.
MAINTENANCE ALERT SYSTEM (MAS):
Activate/Deactivate
Press and hold the LEARN button. Then press the
LIGHT button. The service LED will flash the status;
Active is 2 flashes and deactivated is 3 flashes.
27
Command LED
LOCK Button
LIGHT Button
Service
LED
LEARN
Button
LIGHT
Button