Atlas Copco G2424-S200 Mode D'emploi page 11

G2424-S200
Service
Maintenance instructions
Service recommendations
Preventive maintenance is recommended at regular intervals. See the detailed information on preventive
maintenance. If the product is not working properly, take it out of service and inspect it.
If no detailed information about preventive maintenance is included, follow these general guidelines:
■ Clean appropriate parts accurately
■ Replace any defective or worn parts
Overhaul
WARNING Overspeed could result in serious injury or death
If governor is used, check that correct governor is assembled. Careless handling may put it out of
►
order
Do not disassemble security parts, e.g. speed governor or overspeed shut-off. These parts must
►
be completely replaced when damaged
Always check the free speed of the machine after service. See Section Preparation before using
►
the die grinder
The entire machine should be checked regularly at six-month intervals. If it is in heavy duty service or not
running properly it should be taken out of service more often for inspection.
The strainer at the air inlet should be cleaned frequently to prevent clogging and decreased capacity.
Lubrication instructions
Rust protection and cleaning
Water in the compressed air can cause rust. To prevent rust we strongly recommend to install an air dryer.
Water and particles can cause sticking of vanes and valves. This can be prevented by installing an air fil-
ter close to the product to avoid pressure drop.
Before longer standstills always protect your tool by adding a few drops of oil into the air inlet. Run the tool
for 5–10 seconds and absorb any access oil at the air outlet in a cloth.
NOTICE Do not try to clear the air path using sharp tools.
The air inlet is equipped with a strainer. If this is punctured, foreign objects may harm the valves, resulting
in overspeed.
Lubrication guide
Brand
BP
Castrol
Esso
Q8
Mobil
Klüber Lub.
Texaco
Molykote
EN
© Atlas Copco Industrial Technique AB - 9839 0487 00
General purpose, Bearings and Gears
Energrease LS-EP2
OBEEn UF 1
Beacon EP2
Rembrandt EP2
Mobilegrease XHP 222 NLG 2
Klübersynth UH 1 14-151
Multifak EP2
BR2 Plus
Service
11