Operation - Laserworld Evolution Série Mode D'emploi

Manual: Evolution Series ES-800S RGB 3D
DMX out
DMX in

8. Operation

1. Connect the power cable to the device and then to the mains
2. Use the supplied key to turn on the key switch
3. Press „ON" to switch on your device
Your device runs in auto mode:
4.
Your device runs in music mode:
5.
Control the music-sensitivity by the trim pot at the front side of the device. The LED is
flashing when the device is triggered.
Your device runs in DMX mode if '10' is switched off:
6.
page 7 / 26
DMX address
LED signal
fan Key switch
power switch
connection for
power supply