Dell Networking C1048P Guide De Mise En Route page 30

PE Up Time: 00:01:48
PE Discovery Status: Provisioned PE
User Configured Cascade Ports: Te 0/1(A),Te 0/2(A)
Dynamically Discovered Cascade Ports: None
Cascade LAG: Po 258(Up)
-----------------------------------------------------------
-------------
Stack-id Status
UnitMac No. of Ports
-----------------------------------------------------------
-------------
0 online
11 48
NOTE: In the User-Configured Cascade Ports field, A (active) indicates
that a C9010 port is up (no shutdown) and configured as a cascade
port; I (inactive) indicates that a port is down and configured as a
cascade port.
Dell# show interface port-channel br
Codes: L - LACP Port-channel
O - OpenFlow Controller Port-channel
A - Auto Port-channel
LAG Mode Status
A 258 N/A up
Port Numbering
On the C1048P, the 48 Gigabit Ethernet ports support full-duplex mode
10/100/1000 Mbps speeds on standard Category 5 UTP cable and Power over
Ethernet — PoE (15.4W) and PoE+ (30W).
After the initial C1048P software provisioning is performed, you can configure
L2/L3 and other software features on the C1048P by entering CLI commands
on a C9010 or C1048P console. C1048P interfaces are identified in the
command syntax:
interface peGigE pe-id/pe-stack—unit-id/port-number
where pe-id is a port-extender ID number from 0 to 255; pe-stack-unit-id is a
PE stack-unit number from 0 to 7; port-number is a port number from 0 to
47.
28
Reason Type
- C1048P
Uptime
14:45:26
34:17:eb:00:bb:
Ports
Te 0/1,2 (up)