Dell Networking C1048P Guide De Mise En Route page 20

CAUTION: Before installing the C1048P in a rack, disconnect all cables
(if attached) and remove all self-adhesive pads (if attached) from the
underside of the C1048P.
CAUTION: If you plan to install multiple C1048P PEs in a rack, mount
the C1048s from the bottom up. Make sure that the air flow through
the ventilation holes on each C1048P is not obstructed.
1. Align the holes on the right rack-mount bracket with the holes on the
right side (facing you) of the C1048P.
2. Secure the bracket (item 3 in Figure 10) to the chassis by tightening the
screws (item 2 in Figure 6) provided with the mount bracket.
Figure 6. Attaching Mount Brackets to the C1048P
3. Repeat Steps 1 and 2 to attach the left rack-mount bracket on the
C1048P.
18