Roborock WD1S1A Manuel Utilisateur page 14

Instructions for Use
Emptying the Dirty Tank
1. Push the Dirty Tank Release and remove the tank.
2. Hold the handle firmly with one hand and gently lift off the cover.
3. Pour out the dirty water, then remove and empty any dirt from
the filter cartridge at the bottom of the cover.
4. Reinstall the filter cartridge and put the cover back on.
5. Tilt the dirty tank as shown, then tilt it upwards to lock it in place.
Note: The filter cartridge prevents dirt from blocking the water pipe. It can be removed if it
is deemed unnecessary.
Standby and Power Off
When stopped, the vacuum will go into standby, and its screen will
display the battery level and current mode. It will turn off entirely if
left idle for 5 minutes in standby.
14