Pattfield Ergo Tools PE-1506 Traduction De La Notice D'origine page 71

DRAINING THE TANK
1 Make sure, the compressor is switched
off. Rotate the unloading nut of the
safety valve 5 and pull the valve rod to
release any residing pressure.
Put a container under the drain
and rotate the drain valve slowly coun-
ter-clockwise.
TESTING THE SAFETY VALVE
1 Switch on the compressor. When pres-
surized rotate the unloading nut of the
safety valve 5 and pull the valve rod
until you hear escaping air. Re-tighten
nut.
Never use the compressor, if air leaks
after releasing or if the valve is stuck.
INCREASING THE OUTPUT PRESSURE
1 Turn the pressure regulator
wise. The pressure gauge 2 shows the
output pressure.
Warning! Do not exceed the pres-
sure given in the manual of the con-
nected tool or inflatable equipment.
DISCONNECTION
1
Caution! Before disconnection:
Switch off and unplug compressor.
Release output pressure by fully rotating
the pressure regulator counterclockwise.
3
Press the latch of the adaptor
to disconnect the nozzle.
140 EN
2 Rotate drain valve 6 clockwise until
tightly closed.
Dispose of the drained condensate in
valve 6 compliance with local regulations.
Have the safety valve replaced at your
HORNBACH-Store.
Warning! Use of a compressor with
defective safety valve can result in
death or serious personal injury.
REDUCING THE OUTPUT PRESSURE
4 clock- 2 Turn the pressure regulator 4
clockwise to reduce the output pres-
sure. Wait, until the pressure
shows the desired pressure.
2 Firmly hold the end of the coiled hose.
Retract the retaining sleeve and pull out
the connector.
hose 11
1
1
counter- 1
gauge 2
1
3
2
2
2
1. 1.
2. 2.
EN 141