Operating Procedures; I Basic Operation; G Power On; G Communications With Customers (Talk) - Panasonic WX-C3010 Mode D'emploi

Operating Procedures

I Basic Operation

G Power ON

Press the Power ON/OFF Switch of the center module to turn
the power supply ON.
It takes about 5 seconds until the power supply is started.
Then, press the Power buttons of the Order Taker and the
All-in-One Headset to turn their power supplies ON.

G Communications with Customers (TALK)

Store personnel wearing the headset can communicate bidi-
rectionally with any customer who is at the menu board.
In regard to the method of talking, refer to the operating
instructions of the Order Taker (WX-T3020) or the All-in-One
Headset (WX-H3050).
G Communications with other Store Personnel
(PAGE)
Store personnel wearing the headset can communicate with
each other without being heard by customers.
In regard to the method of paging, refer to the operating
instructions of the Order Taker (WX-T3020) or the All-in-One
Headset (WX-H3050).

G Double Drive-Thru Lane Changeover

In the case of double drive-thru, it is possible to talk or page
by selecting either Lane A or Lane B.
In regard to the method of lane changeover operation, refer
to the operating instructions of the Order Taker (WX-T3020)
or the All-in-One Headset (WX-H3050).

G Power OFF

To turn the power supply OFF, keep pressing the Power but-
ton of the Order Taker or the All-in-One Headset for more
than 2 seconds.
Lastly, press the Power ON/OFF switch of the center module
to turn its power supply OFF.
12

I Convenient Functions

G Auto Talk Lock

When a customer approaches the menu board, it is auto-
matically possible to make the predetermined personnel's
headset (Order Taker or All-in-One Headset) stay in TALK
state. (The Talk Lock Mode is assumed.)
In regard to the method of Auto Talk Lock Mode setup, refer
to the operating instructions of the Order Taker (WX-T3020)
or the All-in-One Headset (WX-H3050).

G Manager Mode

You can set one headset (Order Taker or All-in-One
Headset) to the manager mode in a Lane. Refer to the oper-
ation manual of Order Taker or All-in-One Headset about the
setting method. The headset set to the MANAGER MODE
has following functionality.
• The manager can interrupt store personnel's TALK or
PAGE at any time by monopolizing one channel by prior-
ity.
• The Manager can hear audio from POS alone (setting
necessary)
G Speed Team
This SPEED TEAM operation is used at the congestion time.
Doesn't use the outside microphone and speaker. An Order
Taker or All-in-One Headset communicates order from out-
side into the store.s
1. Press the SPEED TEAM button of the Center Module.
OPERATIONAL SETTING
SPEED BEEP
TEAM DAY/NIGHT
ON:DAY
Speed Term On/Off Button
2. The Order Taker or All-in-One Headset allows the opera-
tor to hear the voice prompt of the "SPEED TEAM ON".
3. The Order Taker or All-in-One Headset allows the opera-
tor to communicate by pressing the PAGE button.
4. Press the PAGE button, and communication can be per-
formed in the PAGE-LOCK mode. (Even if the PAGE but-
ton is set to PTP, it operates by PAGE-LOCK.)
OUTSIDE
V/DET T/P
SP LEVEL
OVERRIDE RELEASE
ON:DAY