Transport And Storage; Troubleshooting - Wolf Garten Lycos 40 Notice D'instructions Originale

EN

Transport and storage

Risk of injuries due to the cutting tool.
¾ Before transport or storage, switch off
the device and wait until the cutting tool
comes to a standstill.
¾ Remove the power pack before transport
or storage.
Storage
Thoroughly clean your device at the end of each
Î
season.
Always store the device in a dry and safe location
Î
that is inaccessible to children.
Risk of injuries or material damage
¾ In case of doubt always take your mower to a specialist workshop.
¾ Before any inspection or any work on the device, switch off the motor and remove the power
pack.
Problem Possible cause
The device switch- The power pack is too hot.
es
The power pack is discharged.
off.
The temperature of the device (electronics) is too
high.
Overcurrent release
The device will not The power pack is discharged.
switch on.
Overvoltage release
switching the device
on
Overcurrent release
Power pack temperature too high or too low
The power pack is defective.
The cutting blade The cutting blade is blunt.
becomes hot.
There is a lot of friction because of a lack of
lubrication.
Uneven running, The cutting blade is damaged.
severe vibration of
The cutting blade fastening has come loose.
the hedge trimmer.
24
WARNING!
Store the power pack and hedge trimmer sepa-
Î
rately.
Store the power pack in a cool and dry location.
Î
Recommended storage temperature 0 - 23°C.
Keep the hedge trimmer and especially its plastic
Î
components away from brake fluids, petrol,
mineral oil containing products, penetrating oils
etc. They contain chemical substances that can
damage, attack or destroy the plastic components
of the hedge trimmer.
Fertilizers and other garden chemicals contain
Î
substances that may have a highly corrosive
effect on the metal parts of the hedge trimmer.
Therefore do not store your hedge trimmer in the
vicinity of these substances.

Troubleshooting

WARNING!
Remedy
Allow the power pack to cool.
Charge the power pack.
Allow the device to cool and if necessary,
clean the ventilation slots
If this occurs again take your device to a
specialist workshop.
Charge the power pack.
If this occurs again take your device to a
specialist workshop.
If this occurs again take your device to a
specialist workshop.
Allow the power pack to cool down or
warm up.
Replace the power pack.
Consult a specialist workshop.
Oil the cutting blade.
Consult a specialist workshop.
Consult a specialist workshop.
Transport and storage