Servicing - Wolf Garten Lycos 40 Notice D'instructions Originale

Servicing

3 The handle engages in the next locking
position 2 .
To rotate the handle further, pull the locking
Î
lever 1 again.
Switching the device on B
With one hand maintain the on/off switch on the
Î
handle depressed 1 .
Then with the other hand simultaneously press the
Î
on/off switch on the bow-shaped handle 2 .
3 The device is in operation.
Press the eco button 3 .
Î
3 The speed of the cutting blade reduces. The lamp
on the eco button goes green.
Note
Eco mode extends device running time by
about 50% and can be used to cut thinner
branches and twigs. Eco mode remains
active after switching the device off and on.
To switch eco mode off, the eco button must
be pressed again so that the device can
work in normal mode (fast cutting blade
speed).
Cutting D E F
Cutting the top of the hedge D
- To cut the hedge top, perform swinging/sweeping
movements to the left and right using the hedge
trimmer.
- For optimum cutting results, maintain the cutting
blade in a slightly inclined position in the direction
of the cutting movement.
Cutting the hedge sides E
- If the hedge sides are to be cut, start at the bottom
part of the hedge and cut upwards.
- For optimum cutting results, maintain the cutting
blade in a slightly inclined position in the direction
of the cutting movement.
- Cut the sides of the hedge so that the hedge nar-
rows towards the top. This ensures uniform hedge
growth.
Cutting tips
- Please remember the breeding season of birds!
- The ideal shape for hedge cutting is trapezoidal,
which allows enough light and air to reach all parts
of the hedge F .
- To promote thick growth in young hedges new
shoots should only be shortened by half.
- If the hedge has already reached your desired
height, now shoots can be completely removed.
- To obtain a uniform hedge height, you can tension
a guide line at the desired height and then cut
along this line.
Cutting times
Deciduous hedges
Evergreen hedges
Conifers
Switching the device off B
3 The device switches off as soon as you release
either of the two on/off switches 1 or 2 .
Remove the power pack G
Press the power pack release 1 .
Î
Remove the power pack 2 .
Î
Servicing
Risk of injuries or material damage.
¾ Only clean or service the device if the
motor is stationary and also the cutting
tool.
¾ Always remove the power pack prior to
working on the device.
¾ Repair and service work as well as the
replacement of safety elements must
be performed by a qualified expert or
workshop.
Cleaning
Clean the hedge trimmer after every use, espe-
Î
cially the ventilation slots, using a dry cloth or, in
the event of heavy soiling, a brush.
Carefully clean the cutting blade after each use.
Î
After use, spray the cutting blade with conditioning
Î
oil to ensure a long service life for the hedge
trimmer. Where possible, use an environmental-
ly-friendly lubricant.
Do not oil the hedge trimmer during use.
Î
To oil the hedge trimmer, place it on its side and
Î
apply a thin oil film to the cutting blade.
During extended periods of hedge cutting, inter-
Î
rupt your work frequently to oil the hedge trimmer
cutting blade.
Attention!
Do not clean the device with water.
May/June and October (per-
form pruning by about 1/3 of
the total height in winter)
April and October
April and October
WARNING!
EN
23