Table des Matières
Publicité
TRIM FUNCTION
RESET FUNCTION
BEGINNER / PRO MODE
GB // 22
If, while flying, the model tends to drift in a particular direction, this
can be corrected with the trim function.
Enabling trim function (see fig.):
• Transmitter beeps and-LED on transmitter flashes
• Move right control lever in the direction to be trimmed
Function: LED flashing status indication:
Trim forwards
2 x front
Trim backwards
2 x rear
Trim left
2 x left
Trim right
2 x right
The model is now in trim mode.
Now correct the model in the desired direction using the right
control lever.
When you have finished, disable the trim function on the transmit-
ter. (see illustration)
The LED on the transmitter will now be continuously lit.
If, after a crash, the model will no longer fly, even after calibration, it
must be fully reset.
• Press the button at upper right on the transmitter (transmitter
will beep)
• move the right control lever in a circle, clockwise (Quadcopter
status LEDs flash)
• Reset function completed (Quadcopter status LEDs continuously
lit)
This function allows you to choose between three speed levels.
This changes the model's agility.
Level 1 (1xpeep) = beginner
Level 2 (2x peep) = advanced
Level 3 (3x peep) = Pro
Publicité
Chapitres
Table des Matières
