Getting The Quadcopter Ready For Take-Off; Calibration Function - Carson X4 Quadcopter Nano Cage Manuel D'instructions

GETTING THE QUADCOPTER READY FOR TAKE-OFF

Now we're good to go! But before lift off, make sure that you have read this manual through completely.
1
Push the throttle lever fully down and then switch on the transmit-
ter.
3
Now move the throttle lever completely up and then back down.
The quadcopter is now ready to launch.

CALIBRATION FUNCTION

This is how to reset the copter. Before every flight, the quadcopter must be calibrated to ensure stable and safe flight. This function should
also be used after a hard landing or a crash.
2
GB // 20
ON/OFF
2
Switch on the copter and place it on a flat surface.
1. Place the model on a level surface. Move the right control lever
in a circle. Calibration (LEDs on the model flash). Calibration
completed (LEDs continuously lit).
2. Move left control lever to start the model.
1
ON/OFF
Switch