Service Information; Leg Glide Replacement (All Models) - Stryker 4850 Manuel D'utilisation Et D'entretien

LEG GLIDE REPLACEMENT (ALL MODELS)

English
Tools Required:
• Hammer
• Slotted Screwdriver
Procedure:
1 . Flip the chair or ottoman upside down, so the legs are off the ground .
Note: Place a sheet or equivalent on the floor to protect the chair or ottoman fabric from damage .
2 . Using a hammer and slotted screwdriver, carefully remove the damaged leg glide (A) from the leg (B) as shown in
Figure 7 (ottoman leg) or Figure 8 (chair leg) . Discard the glide .
3 . Using a hammer, install the new leg glide by hitting it into the chair or ottoman leg until it is flush with the end of
the leg .
Note: The leg glide is tapered . Before installing, make sure that the thinner side is positioned inward to the middle
of the chair or ottoman .
4 . Flip the chair or ottoman back upright .
5 . Verify proper operation of the unit before returning it to service .
Figure 7: Ottoman Leg Glide Replacement
Return To Table of Contents
1-16

Service Information

B
A
4850-009-001 REV G
Figure 8: Chair Leg Glide Replacement
B
A
www.stryker.com