Seat Cushion Replacement (All Models) - Stryker 4850 Manuel D'utilisation Et D'entretien

SEAT CUSHION REPLACEMENT (ALL MODELS)

Tools Required:
• #3 Phillips Screwdriver
Procedure:
1 . Flip the chair upside down, so the chair legs are off the ground .
Note: Place a sheet or equivalent on the floor to protect the chair fabric from damage .
2 . Using a #3 Phillips screwdriver, remove the four screws (A) that secure the seat cushion (B) to the chair frame (C)
and remove the cushion (Figure 11) . Discard the cushion and screws .
3 . Using a #3 Phillips screwdriver, install the supplied four screws to secure the new seat cushion to the chair frame .
Start each screw first, then tighten all four .
4 . Flip the chair back upright .
5 . Verify proper operation of the unit before returning it to service .
B
www.stryker.com
Service Information
Figure 11: Seat Cushion Replacement
4850-009-001 REV G
C
A
Return To Table of Contents
1-19
English