Cleaning; Fabric Cleaning And Maintenance - Stryker 4850 Manuel D'utilisation Et D'entretien

FABRIC CLEANING AND MAINTENANCE

WARNING
Failure to properly clean a contaminated surface will increase the risk of exposure to bloodborne pathogens .
Follow these instructions to ensure that you are cleaning your Stryker Medical fabrics (vinyl, PVC-Free, PVC-Free with
Agion ® , Crypton ® , Crypton ® Green, or Woven Agion
cause damage to the material and hinder its performance .
CAUTION
• Use a soft, white cloth to clean stained or soiled areas . Avoid use of paper towels .
• Cleaning products may be harmful to your skin and/or eyes . Use protective gloves and eye protection . Protect the
surrounding area and clothing from exposure to cleaners . Do not inhale or swallow any cleaning agents . Follow
all cleaning product manufacturer's warnings .
• The use of certain agents can be harmful to the surface appearance and lifespan of fabrics . Check compatibility
of any cleaning product with other surfaces on the furniture, such as painted surfaces or varnish .
• Clean all stains immediately as some stains may become permanent if not removed quickly .
• This information is not a guarantee and does not relieve the user from the responsibility of the proper and safe use
of these fabrics and all cleaning agents .
Vinyl
Clean all stains as quickly as possible and use the following cleaning procedures in order for best results .
CAUTION
When cleaning vinyl fabrics, the use of conditioners or protectants is not recommended and should be avoided .
Cleaning Protocol A (see table on
• Remove excess spill with a damp, clean cloth . Clean with a 10 percent mixture of liquid soap and warm water .
Rinse with water and dry .
• For stubborn stains, use a straight application of commercially available butyl-based water solvent cleaner . Wipe
with a clean cloth . Rinse with water and dry .
• If the stain persists, use a 1 to 1 mixture of isopropyl alcohol and water . Rinse thoroughly with water and then pat
dry with a clean, lint-free cloth . If the stain persists after six attempts, then the stain has set and probably cannot
be removed .
• For more stubborn or difficult stains, use a 9 to 1 mixture of bleach and water (10 percent bleach to 90 percent
water mixture) . Rinse with water and dry . If the stain persists, use a clean cloth saturated with the diluted cleaning
material and rub the stain in a circular motion . Pat dry with a different clean cloth . Repeat, if necessary .
Cleaning Protocol B (see table on
• Remove excess spill with a damp, clean cloth . Clean with a 10 percent mixture of liquid soap and warm water .
Rinse with water and dry .
• For stubborn stains, apply a solution of liquid cleanser and water with a soft brush . Wipe away the residue with
a damp, clean cloth . Dampen a white, clean cloth with a solution of household bleach (10 percent bleach to
90 percent water mixture) . Rub gently . Rinse with a damp, clean cloth to remove the bleach concentration .
• If the stain persists, allow a 1 to 10 diluted mixture of bleach and water to puddle on the affected area or apply
with a damp, clean cloth for approximately 30 minutes . Rinse with a damp, clean cloth to remove any remaining
bleach concentration .
www.stryker.com

Cleaning

® ) thoroughly and safely . Deviating from these instructions may
page 1-12):
page 1-12):
4850-009-001 REV G
Return To Table of Contents
1-11
English