Télécharger Imprimer la page

Kohler K-3611 Guide D'installation Et D'entretien page 9

Publicité

Garantía limitada de un año (cont.)
garantía implícita o a la exclusión o limitación de daños particulares, incidentales o
indirectos, por lo que estas limitaciones y exclusiones pueden no aplicar a su caso. Esta
garantía le otorga ciertos derechos legales específicos. Además, usted puede tener otros
derechos que varían de estado a estado y provincia a provincia.
El presente documento constituye la garantía exclusiva por escrito de Kohler Co.
Troubleshooting Guide
Symptoms
Recommended Action
1.
Poor flush.
A.
Adjust the tank water level to match the waterline.
B.
Fully open the water supply shut-off valve.
C.
Clear obstructions from the trapway, jet, or bowl rim holes.
D.
Clear obstructions from the waste line.
2.
No flush.
A.
Reconnect the flapper chain to the trip lever or flush valve.
B.
Adjust the flapper chain assembly to remove excessive slack.
3.
The fill valve
A.
Adjust the flapper chain for proper slack so the flapper closes.
turns on/off
Clean or replace the flapper if it is worn, dirty, or misaligned
B.
by itself
with the opening.
without the
toilet being
C.
Clean the area around the opening to allow the flapper to seal.
flushed, or it
runs, allowing
Adjust the tank water level if it is too high.
D.
water to enter
E.
Replace the fill valve if the valve float sinks.
the tank.
4.
Tank takes
A.
Fully open the water supply shut-off valve.
excessive time
to fill.
B.
Clean the valve inlet, valve head, or supply line. Flush the
lines.
5.
There is
A.
Partially close the water supply shut-off valve if the water
excessive noise
pressure to the toilet is too high. Check the toilet performance
when the tank
following any such adjustment.
is filling.
B.
Remove dirt or obstructions from the valve head. Flush the
lines.
6.
Trip arm
A.
Adjust the chain to remove excessive slack.
strikes the
tank lid
underside.
Guide de dépannage
Symptômes
Action recommandée
Faible chasse.
Régler le niveau d'eau du réservoir au niveau du repère.
1.
A.
B.
Ouvrir complètement la valve d'arrêt d'alimentation.
C.
Dégager toutes obstructions du siphon, du jet ou des trous du
rebord de la cuvette.
D.
Dégager toute obstruction de la ligne d'évacualtion.
Kohler Co.
9
1066805-2-B

Publicité

loading