Aqua Medic Percula Serie Mode D'emploi page 13

1. Product description
The aquarium system PERCULA can be delivered in 2 sizes, Percula 90 and Percula 120.
Percula 90
 1 x aquarium 90 x 60 x 61 cm, incl frame
 1 x cabinet
 aquastarlight 1 x 150 Watt including
aqualine 10000 bulb
 1 x Protein Skimmer Turboflotor Percula
 1 x post skimming trickle filter with
circulation pump (1,000 l/h)
 2 x filtered circulation pumps (1,000 l/h
each)
 Dimensions: 90 x 60 x 131 cm
Not included in shipment: heater stick, wall mounting for the lighting system, timer and socket
board.
The power of the required heater stick depends on the temperature of the aquarium environment.
If it is installed in an unheated room, it should have a power output of approx. 250 Watt. In heated
rooms, 100 - 150 Watt is sufficient.
The lighting aquastarlight can be fixed by using chains, wire cables or our wall fastening
aquawall. The lamp must not be positioned directly on the aquarium but should be fixed 20 – 30
cm above the water surface.
2. Cabinet's assembly
The assembly of the cabinet is done according to the following drawing.
Take care that the bore-hole of the cabinet plate is located on the right side of the cabinet. The
door where you can hide the socket board has to be fixed at the right side as well.
3. Set-up of the aquarium
The aquarium can be placed directly onto the cabinet. Beforehand, any dust on the plate should be
removed to avoid a bursting of the bottom glass caused through grains of sand or other coarse
particles.
The cable shaft (14) of the aquarium must be positioned above the bore hole of the cabinet.
Percula 120
 1 x aquarium 122 x 66,5 x 66 cm, incl. frame
 1 x cabinet
 aquastarlight 2 x 150 Watt including
aqualine 10000 bulb
 1 x Protein Skimmer Turboflotor Percula
 1 x post skimming trickle filter with
circulation pump (1,000 l/h)
 2 x filtered circulation pumps (1,000 l/h
each)
 Dimensions: 122 x 66,5 x 131 cm
13