Pre-Operation - Campbell Hausfeld PW2575 Manuel Du Produit

Operating Instructions and Parts Manual
Important Safety Instructions
(Continued)
• Always hold gun and wand firmly
when starting and operating the
machine.
• NEVER allow the unit to run with
the trigger released (off) for more
than one minute. Resulting heat
buildup will damage the pump.
• NEVER store the pressure washer
outdoors or where it could freeze.
Freezing temperatures can seriously
damage the pump.
• Release the trigger when changing
from high to low pressure modes.
Failure to do so could result in
damage to the nozzle.
Keep hose away
from sharp objects.
bursting hoses may cause injury.
examine hoses regularly and replace
if damaged. do not attempt to mend a
damaged hose.

Pre-operation

uNPaCkING
Remove the equipment and all parts
from the carton. The carton should
contain the following.
• One pressure washer (pump, engine,
cart base)
• One cart handle assembly
• One spray gun
• One lance with nozzle (additional
lance optional)
• One high pressure hose
• One pack of nuts, bolts, and manuals
• One bottle of engine oil
If any parts are missing, Do Not
returN tHe uNIt to tHe retaIler.
Know the unit's model number (located
on the serial number tag on the
pressure washer frame) and call 1-800-
330-0712 for replacement parts.
After unpacking the product, inspect it
carefully for any damage that may have
occurred during transit. Make sure to
tighten fittings and bolts before using
the pressure washer.
do not operate the
unit if it's damaged
during shipping, handling, or use.
www.chpower.com
Brass
Thermal
Swivel
Relief
Adapter
Valve
Pump
Garden
Inlet
Hose
Figure 2 - Pump hook up
damage could result in bursting and
cause injury or property damage.
aSSeMbly
Use two adjustable or 7/16 inch
wrenches to assemble the pressure
washer.
1. Slide the handle assembly over the
lower legs of the cart base. Use the
standard nut and bolt to secure the
right rear leg. See Figure 1.
Figure 1 – assemble Handle
2. Attach detergent tank to backside of
handle. Use the 4 hex bolts with flat
washer under hex head and 4 nuts
provided.
3. Slide clear plastic hose attached
to leg onto plastic hose barb of
detergent tank (see Figure 3).
4. brass Swivel adaptor (See Figure
2). If it's not already attached to
the pump inlet, assemble the brass
swivel adapter and attach it to the
pump inlet (See Figure 4 and Figure
5). Be sure to connect the correct
side of the brass swivel adapter to
the pump.

Chemical Injector
Hose Barb
Pump
Outlet
Figure 3 – attach suction tube to barb
fitting
Connect This
End To Garden
Hose
Washer With
Filter Screen
Figure  - brass swivel adapter
Brass Swivel
Adapter
Pump Inlet
Figure 5 - Connect the brass swivel to
the pump
High
Pressure
Hose
Washer
Connect This
End To Pump