High Pressure Soap Lance - Campbell Hausfeld PW2575 Manuel Du Produit

High Pressure Soap lance

Safety Section
This manual contains information
that is very important to know and
understand. This information is
provided for SAFETY and to PREVENT
EQUIPMENT PROBLEMS. To help
recognize this information, observe the
following symbols.
warning indicates
a potentially
hazardous situation which, if not
avoided, could result in death or serious
injury.
Caution indicates a
potentially
hazardous situation which, if not
avoided, may result in minor or
moderate injury.
notice indicates
important
information that, if not followed, may
cause damage to equipment.
• do not spray flammable liquids such
as gasoline.
• never place eyes or face close to
water spray or attachments.
• Keep away from children. This
product is not intended for
recreational use by children.
• do not drink from this device.
• To prevent water supply
contamination, only use this product
when a back flow prevention device
is present.
Description
The High Pressure Soap Lance is an
accessory that connects to the gun
of your pressure washer. With this
device you can spray liquid soap at
high pressure from a tank conveniently
attached to the lance, or you can spray
soap at low pressure from the existing
soap injection system on your pressure
washer. Use the high pressure soap
spray to get to those hard-to-reach
areas on your house, truck or RV. Use
the low pressure spray for gentle
soaking of your vehicle, patio, or deck.
Hose barb
Connector
tube
If lance is not already attached to the
tank ...
assembly Instructions
1. Place the tank on a sturdy, flat
surface. Then wedge metal shaft of
lance between the three "fingers"
on top of tank (see Figure 1). NOTE:
The fit is very tight. Use caution to
prevent damage. Heating the center
finger with a hair dryer will make
installation easier.
2. Slide free end of connector tube
onto hose barb attached to head of
lance (see Figure 1).
3. To attach lance to spray gun, push
brass end of lance into gun and
twist.
• Follow manufacturer's label
directions for correct concentration
of soap/detergents.
• when not in use, always keep in
"off" position to prevent leakage.
• To prevent accidental exposure
to cleaning chemicals or possible
leaking, do not store detergent in
tank when not in use.
to Fill Soap tank
1. Slide connector tube off hose barb.
2. Optional: For easier filling, detach
tank from lance.
3. Remove cap
assembly by
rotating cap
counterclock-
wise 1/4 turn to
Figure 2
align arrow on
cap with tab on
tank (Figure 2). Pull cap off.
4. Add cleaning solution (Figure 3).
See manufacturer's instructions for
13
"Fingers"
information on
specifications
and proper
use of cleaning
solution.
Figure 3
5. To replace cap,
align arrow on cap with tab on tank,
then push cap on and turn clockwise
1/4 turn until it locks into place.
6. If tank was removed, reattach it to
metal shaft of lance.
7. Reattach free end of connector tube
to hose barb.
High Pressure operation
1. Make sure pressure washer is
running.
2. Rotate indicator
on cap to the
"On" position
to apply soap
(Figure 4).
Figure 
3. Pull back on
black nozzle to
ensure lance is
in high pressure
mode (Figure 5).
4. Twist nozzle
Figure 5
cover to adjust
spray pattern
from jet to wide
fan spray (Figure
6).
5. Before rinsing,
Figure 6
move indicator
on cap to "OFF"
position to shut
off soap (Figure
7).
6. Water-to-soap
ratio: 12 to 1
Figure 7
www.chpower.com
PW2575
Figure 1