auna IR-120 Mode D'emploi page 18

Network Setup
WPS
Configuration > Network > Wi-Fi Network > Add/Remove AP > Add AP (WPS button. Press OK to select. Invoke
the WPS function of the target Wi-Fi router (see the user manual of the target Wi-Fi router). The radio and the Wi-
Fi router will exchange security information to complete the association process. If the configuration is not done
within one minute, the radio will exit the process and the user is required to repeat the process again. Always place
the radio within 2 meters of the Wi-fi router to ensure smooth and fast association.
Wi-Fi password entry
When the radio is used the first time (or moved to a new premise), after the "Boot up and connect to www.skytune.
net" message, a prompt to configure network will pop up. Choose [Yes] by pressing [ ] and press Select. Select
[Add/Remove AP], then [Add AP (Scan)] to scan the air for available Wi-Fi AP. A list of APs with reasonable signal
strength will be shown. Choose the target Wi-Fi AP and enter the password (if any)
To enter the password: Dial to choose the character for the first charater position, press OK to enter and move to
the next chracter position and dial to choose thenext character and press OK again.Repeat until the last character
has been entered and then long press OK to confirm the passwrod entry.
If the password entry is correct, the radio will show "Associating" and then "Associatiton complete". The radio will
automatically connect to the AP just associated. The radio will then obtain the necessary network parameter for
Interent connection (with DHCP).
18