TREND T12 Traduction Des Instructions Originales page 12

Wear ear protection.
Wear eye protection.
Visible radiation. Do not stare into light.
Date Code Position - (Fig. A)
The date code (56) , which also includes the year of
manufacture, is printed into the housing.
Example:
2021 XX XX
Year and Week of Manufacture
Description - (Fig. A)
WARNING:
Never modify the power tool or
any part of it. Damage or personal injury could result.
1. Speed control wheel
2. Main handles
3. On/off trigger switch
4. Thumb wheel
5. Height stop rod
6. Plunge lock lever
7. Quick release button
8. Spindle lock button
9. Collet assembly
10. Base plate
11. Multiple position turret stop
12. Depth stop bar
13. 22 mm wrench
14. Quick zero reset ring
15. Quick height adjuster lock
16. Quick height adjuster
17. Pointer
18. Fine adjuster
19. Fine zero reset ring
20. Lock on button switch
Intended Use
The T12 and T14 routers have been designed for
professional heavy duty routing of wood, wood based
materials and plastics.
These routers are intended for routing grooves, edges,
profiles and slots as well as copy routing.
DO NOT use under wet conditions or in the presence of
flammable liquids or gases.
The T12 and T14 are professional power tools.
The T14 is designed so that it can be installed into a
router table. The router may only be installed in tables
that meet the legal safety requirements for router tables.
DO NOT let children come into contact with the tool.
Supervision is required when inexperienced operators
use this tool.
EN - T12/T14
• Young children and the infirm. This appliance is not
intended for use by young children or infirm persons
without supervision.
• This product is not intended for use by persons
(including children) suffering from diminished physical,
sensory or mental abilities; lack of experience,
knowledge or skills unless they are supervised by a
person responsible for their safety. Children should
never be left alone with this product.
CAUTION:
controls, read the following sections.
Plunge Lock Lever - (Fig. B)
The plunge lock lever (6) allows you to stop the working
bit at a specified height.
1. Press down the plunge lock lever (6) until you hear an
audible "Click" when you want to lower the router bit into
the workpiece.
2. You can lower the unit until it reaches your preset
stop.
3. To lock the tool in place along its vertical travel, press
quick release button (7).
Collets - (Fig. C)
WARNING:
with shanks that match the installed collet. Smaller
shank bits will not be secure and could become loose
during operation.
CAUTION:
Never tighten the collet without
first installing a router bit in it. Tightening an empty collet,
even by hand, can damage the collet.
A collet is included with this router.
• 12 mm: Europe
• 1/2": UK & Eire
1. To change collets (35), unscrew the collet assembly
(9)
2. Sharply pull the old collet out of the collet nut (45) and
insert the new collet (35).
3. Push firmly so that the new collet snaps past the
retainer spring in the collet nut.
Multiple Position Turret Stop - (Fig. E)
WARNING:
while the router is running. This will place your hands too
near the cutter head.
The turret stop (11) limits the downward distance that
the tool can be plunged. It consists of three screws of
-12-
Before operating any of the
Projectile hazard. Only use bits
Do not change the turret stop