Installation Of The Remote Control - SPORTSTECH DeskFit200 Manuel

5. INSTALLATION OF THE REMOTE CONTROL

You should hold the remote control in your hand when using your DeskFit200 in order to ensure that
you can stop your device at any time in an emergency situation.
As shown in the following pictures, insert two Micro AAA batteries (1.5V) into the remote control.
+ Accelerate the treadmill
The remote uses a 2.4G radio control. Connect the remote control to your device so that it does not
interfere with other treadmills.
How to connect your remote:
1. Connect the treadmill and turn it on. The LEDs brighten after a long "ring".
2. Press the remote control [SPEED +] and [SPEED] buttons simultaneously, release the the
buttons until the red lamp and the green lamp light up alternately. Now you will hear two
sounds, and the LEDs go off. The remote control and the treadmill are connected.
Button functions:
1. SPEED +: Speed increase.
2. SPEED-: Speed reduction.
3. START / STOP:
- Decelerate the treadmill
6. USING THE REMOTE CONTROL
35
On/off switch