Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

In cooling mode, the room
temperature is lower than
the set temperature; in
heating mode, the room
temperature is higher than
the set temperature.
In dehumidification mode,
the ambient temperature is
low.
There is direct sunlight.
Doors or windows are open;
there are a lot of people; or
The cooling
in cooling mode, there are
effect is not
other sources of heat.
good
The filter screen is dirty.
The air inlet or outlet is
blocked.
The air conditioning is not
Big Noise
placed on a flat surface.
Compressor
Overheat protection starts.
does not work.
The distance between the
machine and the remote
The remote
control is too far.
control does
The remote control is not
not work.
aligned with the direction of
the remote control receiver.
Batteries have run down.
The pipe temperature
Displays 'E2'.
sensor is abnormal.
The room temperature
Displays 'E1'
sensor is abnormal.
16
Change the set temperature.
The machine is placed in a
room with an ambient
temperature of greater
than 17 ℃(62 ℉).
Pull the Curtain.
Close doors and windows,
and add new air
conditioning.
Clean or replace the
filter screen.
Clear obstructions.
Put the air conditioning on a
flat and hard place (to
reduce noise).
Wait for 3 minutes until the
temperature is lowered, and
then restart the machine.
Let the remote control get
close to the air
conditioning, and make
sure that the remote
control directly faces to the
direction of the remote
control receiver.
Replace batteries.
Check the pipe
temperature sensor and
related circuitry.
Check the room
temperature sensor and
related circuitry.
Note: If problems not listed in the table occur or recommended
solutions do not work, please contact the professional service
organization.

Appendix

Fuse Parameters
Type:5ET or SMT
Voltage:250V
Current: 3.15A
Schematic Diagram for Cooling Only model
All the technical and specific parameters,please refer to product
nameplate.
Due to continuous improvement,we reserve the right to change
some design without any notice.
Treatment: Don't put the abandoned machine with other
unsorted waste together. Such waste shall be placed
separately for other special use.
17

Publicité

Chapitres

Table des Matières
loading

Ce manuel est également adapté pour:

Es10113ca-wh

Table des Matières