Connecting The Power To The Unit - Ingeteam INGEREV CITY Ground Manuel D'installation Et Usage

Ingeteam
Bottom trim
1. Install the bottom trim in the ground using four threaded components.
2. Install the charging station on the trim. Fasten the joint using nuts and washers.

7.3.3. Connecting the power to the unit

Cabling requirements
The connection must meet certain requirements:
Connection specifications
Connection type
Number of conductors
Nominal current
Conductor maximum diameter
30
Single phase Three phase
2P + E
up to 64 A
16 mm (2 x 10 mm
2
ABA2020IQM01_B - Installation and Operation Manual
Installing and connecting the unit
3P + N + E
up to 64 A
)
2