Blumfeldt 10030721 Mode D'emploi page 16

EN
16
ASSEMBLY
Lay the stove base (2) on its side and fix three legs (1) with six M6x25
1
screws, washers and nuts. Tighten firmly. Then attach the air vent (4)
and the hanger (12) to the air flap.
Insert the rack (7) into the stove base (2). Fix the front and the two
2
rear connecting plates to the stove base with four M6x20 screws,
washers and nuts. Do not tighten too much.
Install the stove assembly (3) on the stove base (2) as described in
3
the previous step. Align the connecting plates and fix them with four
M6x20 screws, washers and nuts. Tighten firmly.
Attach the grille door (6) and the hanger (13) to the finished oven.
Secure the lower flue to the stove body (3) with three M6x25 screws,
4
washers and nuts. Tighten them firmly. Place the flap on the top of
the lower vent (8). Fix the upper flue (10) to the lower flue (8) with
three M6x15 screws and tighten the screws.
5
Finally, place the extractor hood (11) on the upper vent (10).