Maintenance And Service - Garland 310 DPG Manuel D'instructions

English
7.1. FIXING THE MACHINE AND GUIDANCE
Hold the machine with the harness, hands on the
handles and with the right hand in such a position that
you can action the controls (accelerator and security
switch).
Attention! So as to reduce the risk of loss of control
and possible damages (that could even be fatal) to the
end user and/or those surrounding him, never use this
machine single handedly.

8. MAINTENANCE AND SERVICE

Make periodic inspections of the machine to ensure
that the machine is correct. For a thorough inspection
take the machine to your dealer.
Before performing any maintenance or repair the
machine make sure the engine is off and remove
the spark plug cap. Perform all maintenance of the
machine when is set on a flat and clear surface.
Never try adjustments in the machine if it is running
and / or attache to the user by the harness. Perform
all maintenance of the machine when is set on a flat
and clear surface.
Use only suitable spares to get a proper performance
for this machine. This replacement can be found on
the official distributor of the machine. Using other
sparks may causes risks, damage to the user or
people around the machine.
Carburetor adjustment is complicated and should
be done only by the service.Carburetor regulation
is complicated and should only be carried out by a
service agent. An incorrect regulation of the carburetor
can cause damages to the engine and is sufficient
motive to cancel the warranty.
The removal of security devices, an improper
maintenance, the substitution of elements with non
original elements can cause corporal damages.
8.1. CARE AND MAINTENANCE AFTER USE
Carry out the following operations when you have
finished the work to ensure that the machine is kept in
a perfect condition.
8.1.1. GENERAL MAINTENANCE
Keep clean the machine, especially the fuel tank area
and areas near the air filter.
Maintain your machine clean and in good conditions.
Clean the covers with a humid towel. Never use petrol
or other flammable products to clean the machine.
8.2. PERIODIC MAINTENANCE
Make periodic inspections of the machine to ensure
that the machine is correct.
For a thorough inspection take the machine to your
dealer.
Use only suitable spares to get a proper performance
for this machine. This replacement can be found on
the official distributor of the machine. Using other
sparks may causes risks, damage to the user or
people around the machine.
Carry out maintenance work based on the following
table:
36/128