Start Up Instructions - Garland 200 FW Manuel D'instructions

English

6. START UP INSTRUCTIONS

6.1.LIST OF MATERIALS
This machine includes the following elements that you
will find inside the box:
• Bottom transmission
• Rods (14)
• Extension cable with pliers (15 m)
• Instruction manual
Ensure that all elements listed above are included with
the machine.
Thanks to the quality control checks at the factory it
is highly unlikely that any elements will be missing. If
you were to find any element missing, do not use the
machine until the defect has been repaired or the
machine is complete.
Using the machine with defective parts or without all
the elements can cause severe personal damages.
6.2. MOUNTING THE MACHINE
1. Remove the rod until the cable locking sleeve
comes out
2. Unscrew the cable locking sleeve so that the cable
can slide
3. Connect the red and black cables through the
connector
4. Pull the cable from the base of the bar to allow the
connectors to enter the bar.
5. Insert the rod into the bushing until the screw hole
is in place
6. Insert the bar locking screw into the bushing
7. Tighten the cable lock gland at the base of the rod
8. Insert the rod into the locking sleeve
9. Screw the two hex screws into the red bushing to
lock the rod
6.3 CABLE FIXING PROTRACTOR
26/96