Machine Usage - Garland 200 FW Manuel D'instructions

6.4. START UP / OFF
6.4.1. CHECK POINTS BEFORE STARTING
Do not use this machine if it becomes damaged
or wrongly regulated.
Use this machine for the purpose for which it was
designed. Any other use may be dangerous for the
user to the machine and for people, animals and
things you may have around.
Verify that:
- The machine completely and look for loose parts
(screws, nuts, etc.) and damages.
- The protector is properly attached to the machine.
- Verify that the disk or head is not damaged.
Press, repair or replace everything you need before
using the machine.
Do not use attachments on this machine out of our
recommendations because their use may cause
serious injury to the user, the machine and the people,
animals and things close to the machine.
6.4.2 CONNECTING THE MACHINE TO THE BATTERY.
Connect the pliers of the extension cable to the
battery. The red pliers to the positive terminal of the
battery and the black pliers to the negative terminal of
the battery.
6.4.3. START UP / TURNED OFF
Turning on the machine:
Place the switch in the position ¨I¨ (start).
Disconnecting the machine:
Stop the engine by displacing the switch from the
position to the ¨O¨ position.
6.4.4. POINTS TO BE VERIFIED AFTER MACHINE
STARTS
It is neccesary to pay attention to posible loosening
or overheating of parts of the machine. If you detect
any anomalies stop inmediatly the machine and check
it carefully. In case of failure take the machine to
the repair service. In any case you should continue
working if you feel that the performance is not correct.

7. MACHINE USAGE

Only use this machine for those jobs for which it
has been designed. The use of this machine for other
uses is dangerous and could cause damages to the
user and/or the machine.
Avoid operating the equipment in wet grass, where
feasible. Take special care when using this machine
in the rain or after rain because the ground is slippery
and you can slip.
If you slip or you fall, move the switch to "O" (Off).
Do not rely solely on the warning signs on the
machine. Be always alert.
It is neccesary to pay attention to posible loosening or
overheating of parts of the machine. If you detect any
anomalies stop inmediatly the machine and check it
carefully.
In case of failure take the machine to the repair
service.
In any case you should continue working if you feel
that the performance is not correct.
Remember to always use the machine with clean
27/96
English