Publicité
Les langues disponibles
Les langues disponibles
V4.0
9.
Ensure that there are no obstructions under the load and that the area is
clear before lowering the device.
10. Lower the load in a slow and controlled manner to prevent shock loading.
Shock loading may cause the device to fail and lead to property damage
and/or severe personal injuries.
11. Use quality hydraulic jack oil only. Do not operate the jack in temperatures
lower than -5 °C to ensure that the hydraulic jack oil flows properly and
does not thicken.
LIFTING AND LOWERING VEHICLES
1.
Secure the vehicle before lifting. Set it in parking gear, engage the parking
brake and chock the wheels.
2.
Support the vehicle on areas specified by the vehicle manufacturer only.
3.
Do not allow people to enter a vehicle that is being lifted or moved.
UNPACKING
WARNING! Do not operate the device if any part is missing. Replace the missing
part before operating. Failure to do so could result in a malfunction and
personal injury.
Remove the parts and accessories from the packaging and inspect for damage.
Make sure that all items in the parts list are included.
ASSEMBLY & INSTALLATION
Numbered references in parenthesis (#1) refer to the included Parts List.
1.
Insert the lower handle connector (#20) into the lower handle tube (#18).
Ensure that the holes are aligned. Secure using a screw (#19).
2.
Insert the assembly into the centre slot on the handle socket (#10). Secure
using a bolt (#6).
3.
Connect the slotted pin (#21) to the tie rod 3 (#25) using a nut (#23)
4.
Insert the assembly into the smaller slot on the handle socket. Secure
using a bolt (#6).
5.
Mount the adaptor plate (#43) to the lower handle tube. Secure using
nuts (#45) and U-shaped bolts (#42).
6.
Install the adaptors (#36, #40 and #44) to the plate. Secure using
R-pins (#35).
7.
Connect the inlet air hose (#37) to the air source.
Visit www.princessauto.com for more information
22 Ton Pneumatic Service Axle Jack
8760423
7
Publicité
