Publicité
Les langues disponibles
Les langues disponibles
8760423
OPERATION
LIFTING A LOAD
WARNING! Once the load is lifted to the desired height, support the load with
jack stands to prevent injury should the jack fail. Do not work under a load that
is supported only by a jack.
1.
Close the release valve by rotating the handle knob (#31) clockwise.
2.
Position the saddle directly under the load.
3.
Run the air source at a low volume until the saddle is close to touching
the load.
4.
Extend the screw extension (#45) by rotating it counterclockwise until the
saddle connects to the load. Ensure that the load is centred on the saddle
before lifting it further. Reposition the jack if needed.
5.
Run the air source until the load reaches the desired height.
LOWERING A LOAD
WARNING! Lower the load in a slow and controlled manner to prevent shock
loading. Shock loading may cause the device to fail and lead to property
damage and/or severe personal injuries.
1.
Disconnect the hose from the air source.
2.
Open the release valve by slowly rotating the knob counterclockwise. The
load will descend as pressure is released from the jack's system. Control
the speed by rotating the knob.
a.
Rotate the knob counterclockwise to increase the speed.
b.
Rotate the knob clockwise to decrease the speed.
3.
Once the lifting arm has fully lowered, retract the screw extension by
rotating it clockwise. Disengage the jack from the load.
CARE & MAINTENANCE
1.
Maintain the device with care. A device in good condition is efficient,
easier to control and will have fewer problems.
2.
Inspect the device components periodically. Repair or replace damaged or
worn components. Only use identical replacement parts when servicing.
3.
Follow instructions for lubricating and changing accessories.
4.
Keep the device handles clean, dry and free from oil/grease at all times.
8
22 Ton Pneumatic Service Axle Jack
For technical questions call 1-800-665-8685
V4.0
Publicité
