Télécharger Imprimer la page

Power Fist 8760423 Mode D'emploi page 4

Cric pneumatique/hydraulique

Publicité

Les langues disponibles

Les langues disponibles

8760423
AIR TOOL PRECAUTIONS
1.
Inspect the tool's air hose for cracks, fraying or other faults before each
use. Discontinue use if the air hose is damaged or hissing is heard from
the air hose or connectors, while operating the tool. Replace the defective
component/air hose.
2.
Do not allow people, mobile equipment or vehicles to pass over the
unprotected air hose. Position the air hose away from high traffic areas,
in a reinforced conduit or place planks on both sides of the air hose to
create a protective trench.
3.
Prevent damage to the air hose by observing the following:
a.
Never carry the tool by the air hose.
b.
Keep the air hose behind the tool and out of the tool's work path.
c.
Keep the air hose away from heat, oil, sharp edges or moving parts.
d.
Do not wrap the air hose around the tool as sharp edges may pierce
or crack the air hose. Coil the air hose when storing.
4.
A damaged or disconnected air hose under pressure may whip around and
inflict personal injury or damage the work area. Secure the compressor's
air hose to a fixed or permanent structure with clamps or cable ties.
5.
Install an in-line shutoff valve or regulator to allow immediate control over
the air supply in an emergency, even if a hose is ruptured.
6.
Check the manufacturer's maximum pressure rating for air tools and
accessories. Compressor outlet pressure must be regulated so as to never
exceed the maximum pressure rating of the tool.
7.
Serious injury may occur from loose debris being propelled at high speeds
from the compressed air stream. Always wear OSHA approved safety glasses
to protect the eyes during operation of the air compressor.
8.
Never point the air stream or tools at any point of your body, other people
or animals. Debris and dust may be ejected without warning. Always turn
off the air compressor and drain tank pressure completely before
attempting maintenance or attaching air tools. Release pressure slowly
from the system.
9.
Serious injury or death may occur from inhaling compressed air. The air
stream may contain carbon monoxide, toxic vapors or solid particles. Never
inhale compressed air directly from the pump or air tool.
4
22 Ton Pneumatic Service Axle Jack
For technical questions call 1-800-665-8685
V4.0

Publicité

loading